Construction Method Of Carved Plaster Moldings

1. First, nail wooden blocks to the corners or other locations where installation is required using cement nails. The wooden blocks are generally 15 mm (thickness) × 60 mm (width) × 50 mm (length), spaced approximately 330 mm apart. The nailed blocks must align perfectly with the joints of the sliding blocks on the corner trim.

2. Before installation at each corner, cut a complete floral design from the carved sliding block inside the corner trim, planing off the edges to allow for proper adhesion at the final nailing point.

3. Align the prepared corner trim with the nailed wooden blocks at the corner, push open the carved insert, and drive in 2-3 round nails. Push forward slightly after each block, and finally, glue the last joint with a pre-cut carved design using glass glue to cover the nail holes, achieving a seamless finish.